#1 Parachute Rigging Service in Malaysia
Parachute Rigging Service & Reserve Repack by
FAA Certified Rigger
Reserve due for repack? Bought a used rig? Gear has been sitting for too long?
Before you jump it, get it checked properly.
Skyattack provides parachute rigging service and reserve repack support for skydivers in Malaysia and the surrounding region. This includes gear inspection, parachute assembly, minor repair checks, and practical rigging advice before the equipment goes back in the air.
What we offer?
1. Reserve Repack
If your reserve is due, don’t leave it until the last minute. We can inspect and repack your reserve parachute properly before your next jump or trip.
A reserve repack is not just folding the canopy back into the container. The reserve, freebag, pilot chute, bridle, closing loop, pins, AAD setup, and general container condition need to be checked before the rig is closed.
2. Gear Inspection
Not sure if your rig is still good to jump?
We can check your parachute system for visible wear, damage, poor routing, old components, missing parts, or anything that needs attention before use.
This is useful if the rig has been stored for a long time, recently bought second-hand, or has not been inspected for a while.
5. Minor Repair and Maintenance
Some minor repair and maintenance work may be available after inspection.
This may include small stitching work, basic fabric repair, component replacement, or other minor rigging tasks depending on the equipment condition, material, and manufacturer limitations.
Not every repair can be accepted immediately. The rig must be inspected first before we confirm what can or cannot be done.
3. Used Gear Evaluation
Buying used skydiving gear can save money, but only if the setup is suitable and the condition is acceptable.
Before you buy, we can help check the basic condition, canopy size, reserve size, AAD status, harness fit, and whether the rig makes sense for your experience level.
A cheap rig is not always a good rig.
6. Rigging Advice
Not sure if your container fits your canopy? Not sure about reserve size, AAD status, or whether the rig you want to buy is suitable?
Ask first before you spend money or jump the gear.
We can help you understand the setup better and point out things that may need to be checked properly.
4. Parachute Assembly
Need help setting up a rig?
We can assist with main canopy installation, reserve installation, riser setup, deployment system check, AAD installation check, closing loop setup, and general configuration review.
This is useful for new rigs, replacement canopies, new reserves, or when different components are being combined into one system.
Why It Matters?
- Your parachute system is not just a bag with two canopies inside.
- Small things matter in rigging — an old closing loop, wrong routing, damaged stitching, expired components, poor compatibility, or incorrect assembly can create a serious problem later.
- The goal is simple: check it properly, pack it properly, and make sure the jumper understands what is going on with the gear.
Service by Appointment
- Rigging work takes time and proper attention. Please contact us first before sending or bringing your equipment.
- Need a reserve repack, gear inspection, used gear check, or parachute rigging advice?
- Contact Skyattack to schedule your rigging service appointment.